.и теперь все меню на китайском языке...если кто то знает помогите плиз как вернуть в руский язык...ну или хотя бы в англ
Мож попробовать сбросить принтер в заводские установки . У принтера английский язык должен быть по умолчанию.
В сервисмануале
http://narod.ru/disk/start/13.dl3f-narod.yandex.ru/176443001/ha43c3f5bbf4ef5fcdf7c4da769646560/HP%20LaserJet%20P3010%20(service%20manual).pdf на странице 262 написано:
Product cold reset
A cold reset unlocks menus that have been previously locked and sets all control panel menu items
(including EIO settings) back to the factory defaults. However, it does not clear the values in the Service
mode functions on page 259 menu (such as the serial number and page counts).
NOTE: Before performing a cold reset, print a menu map and a configuration page. Use the information
on the configuration page to reset any customer-set product configuration values that the cold reset
procedure changes.
1. Turn the product off.
2. Turn the product on. When the memory count begins, press and hold the OK button. Continue
holding down the OK button until all three product control-panel lights flash once and then remain
on. This might take up to 10 seconds.
3. After the message SELECT LANGUAGE appears on the display, press the button or the
button until COLD RESET is highlighted.
4. Press the OK button. The product performs a cold reset and then continues its power-on sequence.
5. Check all I/O settings and reset any customer-set product configuration values.
